Item # 12TI10316, Gyrolok® TI Tube Insert On Circle Valve Technologies Inc.

For specific application

HOKE Gyrolok tube fittings may be used with various types of plastic tube material without any special preparation. Use tube inserts to support soft types of tubing, such as Tygon or polyvinyl chloride, prior to insertion into a HOKE Gyrolok end. See chart at lower right for recommendations.

Unit of Measure

Specifications | Dimensional Data | Usage Instruction

Specifications

Description	N/A Tube Insert
Fitting Configuration	N/A Spare Parts
Basic Part No.	N/A TI
Material	N/A 316 Stainless Steel
Tube O.D.	N/A 3/4 in
Tube I.D.	N/A 5/8 in
Optional Materials	N/A 600 - Inconel 6MO - 254 SMO D50 - Super Duplex 2507 DX3 - Duplex 2205 HC - Hastelloy® C-276 M - Monel TI - Titanium
Type	N/A Tube Fittings

Dimensional Data

N/A

Usage Instruction

N/A

Fully insert Tube Insert into plastic tubing, where appropriate.
If using standard nut, follow standard HOKE Gyrolok assembly instructions, page 53 (Hand-tighten, then tighten 1 1/4 turns with wrench.)
For finger-tight assembly, standard Brass fittings are available with knurled nuts and nylon ferrules.

Tubing Material	Front Ferrule	Rear Ferrule	Tube Insert Usage
Polyethylene	Metal Nylon	Metal Nylon	Not normally required
Nylon	Metal Nylon	Metal Nylon	Not normally required
Teflon®	Metal Teflon	Metal Teflon or Metal	Not normally required
Rigid PVC	Metal Teflon*	Metal Teflon*	None
Soft Polyvinyl Chloride or Tygon	Metal Nylon	Metal Nylon	Recommended

Specifications

Description

Fitting Configuration

Basic Part No.

Material

Tube O.D.

Tube I.D.

Optional Materials

Type

Dimensional Data

Usage Instruction